We have a problem. The ditto+ is reading a heat of around 354 C which means that the printer will not heat up because it thinks that to get the the appropriate temperature it needs to cool down. So when we tell it to print something will will just sit there and try to cool down to temperature it cannot cool down to because its temperature is not higher than the temperature we want it at. We think that the issue is with the thermistor because we have checked the wiring for loose connections. If you have any ideas about how to fix this it would be appreciated.

More pictures of the later steps!

We have begun assembling the MakiBox Version 3.

Step 4 putting together the box part was a bit of a challenge.

Finishing the assembly of the 3^rd corner of the base. We also added the motors to the corner base pieces.

Accomplished

-Completed base

-Mounted power supply unit

-Mounted Arduino

Problems

-On the last bar of the base it was a bit difficult to line up the nuts. We found that it helped to have two people and have each person do one side at the same time.